Industrial Air Conditioner Installation Requirements for Factories

Industrial Air Conditioner Installation Requirements for Factories

Industrial Air Conditioner Installation Requirements for Factories

Industrial air conditioner installation requires careful planning of electrical supply, condenser-water circulation, airflow distribution, equipment placement and maintenance access. For large factories and industrial workshops, these factors are just as important as selecting the correct cooling capacity.

Unlike conventional residential air conditioning, industrial cooling systems must operate around production machinery, high ceilings, continuous heat loads and complex building layouts.

A successful industrial air conditioner installation starts with understanding the cooling equipment and its infrastructure requirements. This guide explains seven essential considerations for factory owners, HVAC contractors and MEP engineers evaluating water-cooled DX and hybrid evaporative-assisted cooling systems.

1. Evaluate Factory Cooling Loads Before Installation

Before industrial air conditioner installation begins, the cooling requirements of the building must be established.

Industrial workshops generate heat from machinery, motors, production processes, lighting and outdoor-air infiltration. Cooling demand can vary significantly between different working areas.

Key information includes:

  • Factory length, width and ceiling height

  • Outdoor design temperature and humidity

  • Required indoor temperature and humidity

  • Production machinery and internal heat loads

  • Ventilation and exhaust airflow

  • Operating hours and production schedules

For example, a plastic injection molding workshop may have concentrated heat loads around processing equipment, while a warehouse may require cooling primarily in occupied working zones.

The required cooling capacity should be determined through an appropriate cooling-load assessment rather than floor area alone.

For more information, read our Factory Cooling Solutions for Large Industrial Workshops.

2. Check Electrical Supply Requirements

Electrical compatibility is one of the first technical conditions to confirm during industrial air conditioner installation.

Industrial HVAC equipment may require three-phase electrical power, depending on the selected model and its electrical configuration.

Before installation, contractors should verify:

  • Rated voltage and frequency

  • Single-phase or three-phase supply

  • Rated and maximum electrical current

  • Required circuit protection and isolation

  • Electrical cable sizing and routing

  • Power requirements for pumps and auxiliary equipment

The selected industrial air conditioner must be compatible with the available factory electrical infrastructure.

For water-cooled DX systems, electrical planning must also account for the circulation pump and associated outdoor heat-rejection equipment.

All final electrical arrangements should follow the manufacturer's technical documentation and applicable local electrical requirements.

3. Design the Condenser-Water Circulation System

Water-cooled DX equipment introduces an additional requirement compared with conventional air-cooled systems: a properly designed condenser-water circuit.

In this configuration, the refrigeration system transfers heat from indoor air to circulating condenser water. The water then transports this heat to an outdoor heat-rejection system.

For industrial air conditioner installation using water-cooled DX technology, contractors must evaluate several technical conditions.

Condenser-Water Temperature

The entering-water temperature must remain within the selected equipment's specified operating range.

Water Flow Rate

Adequate water circulation is necessary for proper heat transfer and stable system operation.

Pump Selection and Piping

Circulation pumps and piping should be selected according to required flow, pressure losses, installation distance and system configuration.

Water Quality

Water treatment, filtration and maintenance provisions are important for reducing the risk of scaling, corrosion and fouling.

Outdoor Heat Rejection

The outdoor system must be capable of rejecting the required condenser heat under the local design conditions.

In hybrid evaporative-assisted configurations, outdoor heat rejection may incorporate water evaporation to improve heat-transfer conditions.

However, the effectiveness of evaporative heat rejection is influenced by outdoor wet-bulb temperature, water quality and equipment design.

Condenser-water conditions should therefore be confirmed before equipment selection is finalized.

4. Choose the Right Installation Location

Equipment positioning directly affects airflow performance, service accessibility and the amount of usable production space.

Industrial air conditioner installation generally

Reading next

metal fabrication workshop cooling

Partner With EXINDA

Distributors & Dealers

Expand your HVAC offering with EXINDA heat pumps and ventilation systems, backed by product training and technical support.

Engineering Firms & Contractors

Get the performance data, submittals and engineering support you need to select equipment and move your project forward.

HVAC Brands

Bring your product ideas to market with EXINDA’s engineering, testing and manufacturing expertise.